This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
xpadder for jpcsp help config
#1
psp 
Please help if you can!!! I have Windows 7 64 bit and need help to configure my Xbox 360 controller for JPCSP. I know it is possible becausse I have read it before. The problem is that when I run JPCSP v0.6 1772 and try to configure my Xbox 360 controller into the keys, it wont enter the buttons. It tells me my controller is connected and that it should work fine but none of my buttons register to any keys. If you can help me I will really appreciate it. And please describe in detail or step by step. Thank you!!!
Reply
#2
http://buildbot.orphis.net/jpcsp/

update your emu. r1772 is almost ancient. the gamepad support was added only recently.
Reply
#3
(05-24-2011, 03:40 PM)serio Wrote: http://buildbot.orphis.net/jpcsp/

update your emu. r1772 is almost ancient. the gamepad support was added only recently.

Thankx i'll check it out. I'll reply back if it doesn't work
(05-24-2011, 03:43 PM)broly22 Wrote:
(05-24-2011, 03:40 PM)serio Wrote: http://buildbot.orphis.net/jpcsp/

update your emu. r1772 is almost ancient. the gamepad support was added only recently.

Thankx i'll check it out. I'll reply back if it doesn't work

which is the best one? any specific one?
Thank you soo much serio. This works perfectly now. And you responded quickly. You are better than the others who post.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)